Maytag Repair Jobs and Surveys

"Return to repair with tub, bushing, suspension, and leaking drain hose. Unfortunately, was unable to get unit apart. Tub was seized on the driveshaft. Did not perform bushing and suspension repair. But did install $10 drain hose. Customer can use will still have off balancing issues. Advise customer to start looking for new unit has gold."

Call back warranty customer stated washing machine showing long fill LF code appearing on user interface tested both the hot and cold water valves. Both are in good working condition. Disconnected waterlines at rear found large amount of rust and sediment buildup. Customer has been notified of current issue at hand.

Installed shift actuator test all operations okay

Customer requested to reschedule appointment for control board install for Monday

Installed new drive hub asm and tested all operations okay

Found rear leaking and also found bottom of drain tub is leaking. Just charge service call. No repairs to unit needed.

"Unit is 24 years old. Bad clutch/transmission, parts are NLA. Lid lock and lid hinges broken as well. Recommend replacement."

"Customer wanted inspected. Vent good flow. Unit is quiet, ignites and cycles properly. No issues right now. Recommend possibly having vent cleaned out, had restricted airflow code."

Replace motor. Test operation ok

Installed new push and pull washer cycling knob on Maytag top washing machine

"Install coil kit, Parts under warranty"

"Took out faulty, cam gear, pulley, and belt installed factory replacement on Maytag top load washing machine unit now functioning properly. Customer does have a large load inside. The unit told them they may have to remove the clothes inside due to the weight."

"Long dry times. Vent is good, lights off. Flame sensor, igniter and coils good. Replaced thermistor and tested operation. Fuse and thermostats test good. If symptoms return, may be bad control. ; used 1 WP8577274 (Thermistor) from stock"

Recall. Found bad motor and blower wheel.

Customer states unit not agitating during diagnosis found that the Cam gear was getting hung up and the machine was also intermittently having an issue where it would repeatedly enter the drain cycle without the machine being turned

"F2E2 code, bad console. Possibly bad board as well, recommend replacement due to cost of repairs and part is back ordered."

Removed lint from outside vent. N/C.

Installed thermal fuel

Install blower wheel

Warranty out igniter and installed burner test all operations okay